Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Saito, Tatsuo; Yamazawa, Hiromi*; Mochizuki, Akihito
Journal of Environmental Radioactivity, 255, p.107035_1 - 107035_14, 2022/12
Times Cited Count：0 Percentile：0(Environmental Sciences)The seasonal variation of dissolved U (DU) in Lake Biwa was reproduced by the following model and parameter research. The introduced models are the water-DU mass balance, and the ion exchange between UO
and H
on the lakeshore soil. The optimized parameters were the CEC of the lakeshore, TU as the sum of DU and AU (soil adsorbed U), kads and kdes as the first order reaction rate coefficients during rapid soil adsorption and desorption of U, respectively. Tabulated by the chemical equilibria constituting DU and analyzed the contribution of each chemical species, it is shown that the seasonal variation of DU is caused by the seasonal variation of pH. A correction to the ion-exchange equilibrium to shift to first order rate reaction only when the daily AU ratio increased above kads or decreased below kdes, improved the reproducibility of DU measurements and reproduced the delay of the DU peak from the pH peak.
Matsuda, Shohei; Yokoyama, Keiichi; Yaita, Tsuyoshi; Kobayashi, Toru; Kaneta, Yui; Simonnet, M.; Sekiguchi, Tetsuhiro; Honda, Mitsunori; Shimojo, Kojiro; Doi, Reisuke; et al.
Science Advances (Internet), 8(20), p.eabn1991_1 - eabn1991_11, 2022/05
Times Cited Count：6 Percentile：58.16(Multidisciplinary Sciences)no abstracts in English
Takino, Kazuo; Sugino, Kazuteru; Oki, Shigeo
Annals of Nuclear Energy, 162, p.108454_1 - 108454_7, 2021/11
Times Cited Count：1 Percentile：16.35(Nuclear Science & Technology)
C absorber material on melt progression and chemical forms of iodine or cesium under severe accident conditionsHidaka, Akihide
Insights Concerning the Fukushima Daiichi Nuclear Accident, Vol.4; Endeavors by Scientists, p.341 - 356, 2021/10
O decomposition at the U
O
surface in bicarbonate solutionMcGrady, J.; Kumagai, Yuta; Watanabe, Masayuki; Kirishima, Akira*; Akiyama, Daisuke*; Kitamura, Akira; Kimuro, Shingo
RSC Advances (Internet), 11(46), p.28940 - 28948, 2021/08
Times Cited Count：5 Percentile：38.19(Chemistry, Multidisciplinary)Harada, Masahide; Teshigawara, Makoto; Oi, Motoki; Oikawa, Kenichi; Takada, Hiroshi; Ikeda, Yujiro
Nuclear Instruments and Methods in Physics Research A, 1000, p.165252_1 - 165252_8, 2021/06
Times Cited Count：2 Percentile：34.88(Instruments & Instrumentation)This study explores high-energy neutron components of the extracted neutron beam at J-PARC pulsed neutron source using the foil activation method with threshold reactions. Foils of aluminum, gold, bismuth, niobium, and thulium were used to cover the neutron energy range from 0.3 MeV to 79.4 MeV. The experiment was performed using neutron beams of BL10 (NOBORU). The foils were irradiated by a neutron beam at 13.4 m from the moderator. To characterize high-energy neutron fields for irradiation applications, reaction rates in three different configurations with and without BC slit and Pb filter were examined. To compare the experiments with calculations given for the user, reaction rates for corresponding reactions were calculated by the PHITS code with the JENDL-3.2 and the JENDL dosimetry file. Although there was a systematic tendency in C/E (Calculation/Experiment) ratios for different threshold energies, which C/E ratio decreased as threshold energy increased up to 100 MeV, and all C/E ratios were in the range of 1.0
0.2. This indicated that high-energy neutron calculations were adequate for the analysis of experimental data for NOBORU users.
Nishioka, Shunichiro; Nakajima, Kunihisa; Suzuki, Eriko; Osaka, Masahiko
Journal of Nuclear Science and Technology, 56(11), p.988 - 995, 2019/11
Times Cited Count：12 Percentile：80.27(Nuclear Science & Technology)In order to contribute to improvement of Cs chemisorption model used in severe accident analysis codes, the influence of chemical factors (temperature, atmosphere, concentration of affecting chemical elements etc.) on the Cs chemisorption behaviour onto stainless steel was investigated experimentally. It was found that the surface reaction rate constant used in the current Cs-chemisorption model was influenced by not only temperature, as already known, but also atmosphere, cesium hydroxide (CsOH) concentration in the gas phase and silicon content in SS304. Such chemical factors should be considered for the construction of the improved Cs-chemisorption model. Another important finding is that the chemisorption behavior at lower temperatures, around 873 K, could differ from those above 1073 K. Namely, Cs-Fe-O compounds would form as the main Cs-chemisorbed compounds at 873 K while Cs-Si-Fe-O compounds at more than 1073 K.
Miyahara, Naoya; Miwa, Shuhei; Horiguchi, Naoki; Sato, Isamu*; Osaka, Masahiko
Journal of Nuclear Science and Technology, 56(2), p.228 - 240, 2019/02
Times Cited Count：7 Percentile：61.94(Nuclear Science & Technology)In order to improve LWR source term under severe accident conditions, the first version of a fission product (FP) chemistry database named "ECUME" was developed. The ECUME is intended to include major chemical reactions and their effective kinetic constants for representative SA sequences. It is expected that the ECUME can serve as a fundamental basis from which FP chemical models in the SA analysis codes can be elaborated. The implemented chemical reactions in the first version were those for representative gas species in Cs-I-B-Mo-O-H system. The chemical reaction kinetic constants were evaluated from either literature data or calculated values using ab-initio calculations. The sample chemical reaction calculation using the presently constructed dataset showed meaningful kinetics effects at 1000 K. Comparison of the chemical equilibrium compositions by using the dataset with those by chemical equilibrium calculations has shown rather good consistency for the representative Cs-I-B-Mo-O-H species. From these results, it was concluded that the present dataset should be useful to evaluate FP chemistry in Cs-I-B-Mo-O-H system under LWA SA conditions.
Matsuda, Norihiro; Izumi, Yuichi*; Yamanaka, Yoshiyuki*; Gando, Toshiyuki*; Yamada, Masaaki*; Oishi, Koji*
EPJ Web of Conferences, 153, p.07001_1 - 07001_6, 2017/09
Times Cited Count：0 Percentile：0.03(Nuclear Science & Technology)Iwamoto, Hiroki; Nishihara, Kenji; Iwamoto, Yosuke; Hashimoto, Shintaro; Matsuda, Norihiro; Sato, Tatsuhiko; Harada, Masahide; Maekawa, Fujio
Journal of Nuclear Science and Technology, 53(10), p.1585 - 1594, 2016/10
Times Cited Count：18 Percentile：85.7(Nuclear Science & Technology)Kasugai, Yoshimi; Harada, Masahide; Kai, Tetsuya; Oi, Motoki; Meigo, Shinichiro; Maekawa, Fujio
JAEA-Data/Code 2015-033, 28 Pages, 2016/03
JAEA-Data-Code-2015-033.pdf:1.78MB
The high-energy neutron fluxes and spectra around the mercury spallation neutron source at MLF of J-PARC were measured by the multi-foil activation method. The threshold energies of neutron reactions utilized in this experiment covered from 0.1 to 50 MeV. The foil irradiation was carried out on the first beam-run of MLF from May 30th to 31th, 2008. After the irradiation, the induced radioactivity of each foil was measured using an HPGe detector, and the neutron-induced reaction-rate distribution around the mercury target was determined. Using these data, the high-energy neutron fluxes and spectra were deduced with unfolding method in which the neutron spectra calculated with PHITS code were used as the initial-guess spectra. By comparison between the initial and the unfolded spectra, it was shown that most of the calculation results, which had been the basis of the neutronics design of the MLF target assembly, were consistent with the experimental data within 30%.
Iwai, Yasunori
Fusion Engineering and Design, 98-99, p.1796 - 1799, 2015/10
Times Cited Count：5 Percentile：39.96(Nuclear Science & Technology)Hydrophobic platinum catalysts have been widely applied in the field of nuclear fusion for the exchange reactions of hydrogen isotopes between hydrogen and vapor in the water detritiation system, and for the oxidation of tritium on the atmospheric detritiation system. Hydrophobic platinum catalysts are hardly susceptible to water mist and water vapor. Hydrophobic platinum catalysts are produced by supporting platinum directly on hydrophobic polymer beads. For the hydrophobic polymer, styrene - divinyl benzene (SDB) has been applied in Japan. It can be pointed out that the upgrade in catalytic activity of hydrophobic catalyst is expected to downsize the catalytic reactor based on a hard look at a large increase in flow rate in future. The upgrade in catalytic activity of two types of commercial Pt/SDB catalysts was found when they were irradiated with electron beams. After irradiation with electron beams, the catalytic activity was evaluated by means of overall reaction rate constant for the oxidation of tritium. The overall reaction rate constant increased as increase in dose. The constant showed the peak value in the dose between 500 to 1000 kGy. After the peak, the constant decreased as increase in dose. The overall reaction rate constant at the peak was 6 times larger than that evaluated with unirradiated. The mechanical strength of irradiated Pt/SDB kept sound until 1500 kGy. The irradiation is a promising method to the upgrading in catalytic activity of Pt/SDB catalyst.
C absorber material on melt progression and chemical forms of iodine or cesium under severe accident conditionsHidaka, Akihide
Nihon Genshiryoku Gakkai Wabun Rombunshi, 14(1), p.51 - 61, 2015/03
BC used mainly for BWR and EPR absorbers could cause phenomena which never happen in PWR with Ag-In-Cd absorbers during severe accident. BC would make a eutectic interaction with stainless steel and enhance melt relocation. Boron oxidation could increase H generation and change of liberated carbon to CH could enhance CHI generation. HBO generated during BC oxidation could be changed to CsBO by combining with Cs. This may increase Cs deposition in reactor coolant system. There could be differences in configuration, surface area, stainless steel-BC weight ratio between BC powder and pellet absorbers. Present issue is to clarify effect of these differences on full scale melt progression, BC oxidation and source term. Advancement of this research domain could contribute to further sophistication of prediction tool for melt progression and source terms, and treatment of organic iodide formation in safety evaluation.
Hakoda, Teruyuki; Kojima, Takuji
Radiation Physics and Chemistry, 74(5), p.302 - 309, 2005/12
Times Cited Count：0 Percentile：0.01(Chemistry, Physical)no abstracts in English
Verzilov, Y. M.; Ochiai, Kentaro; Nishitani, Takeo
Fusion Science and Technology, 48(1), p.650 - 653, 2005/07
Times Cited Count：7 Percentile：44.9(Nuclear Science & Technology)no abstracts in English
systemKurosaki, Yuzuru; Takayanagi, Toshiyuki*
Chemical Physics Letters, 406(1-3), p.121 - 125, 2005/04
no abstracts in English
Kida, Takashi; Sugikawa, Susumu
JAERI-Tech 2004-019, 30 Pages, 2004/03
JAERI-Tech-2004-019.pdf:1.23MB
It is known that hydrazine nitrate used in nuclear fuel reprocessing plants is an unstable substance thermochemically like hydroxylamine nitrate. In order to take the basic data regarding the reaction of hydrazine nitrate with nitric acid, initiation temperatures and heats of this reaction, effect of impurity on initiation temperature and self-accelerating reaction when it holds at constant temperature for a long time were measured by the pressure vessel type reaction calorimeter etc. In this paper, the experimental data and evaluation of the safe handling of hydrazine nitrate in nuclear fuel reprocessing plants are described.
Ohashi, Hirofumi; Inagaki, Yoshiyuki
JAERI-Tech 2003-046, 47 Pages, 2003/05
JAERI-Tech-2003-046.pdf:3.15MB
no abstracts in English
Np and 
Am through loess mediaTanaka, Tadao; Mukai, Masayuki; Maeda, Toshikatsu; Matsumoto, Junko; Ogawa, Hiromichi; Li, Z.*; Wang, X.*; Fan, Z.*; Guo, L.*; Liu, C.*
Journal of Radioanalytical and Nuclear Chemistry, 256(2), p.205 - 211, 2003/05
Times Cited Count：3 Percentile：25.79(Chemistry, Analytical)Migration experiments of Np(V) and Am(III) have been performed using a column system, to investigate migration behavior of Np and Am through a column packed with loess, taken from Shanxi, China. Adsorption mechanisms of Np and Am on the loess were examined by a chemical extraction method. In the case of the Np, most of Np adsorbed on the influent edge of the column. The Np adsorbed on the loess was mainly controlled by surface complexation. However, the migration of Np in the loess media could be roughly evaluated by using the distribution coefficient. In the case of the Am, particulate Am species was formed in the influent solution and moved in the column. The Am adsorbed on the loess was controlled by irreversible reactions. The migration behavior of particulate Am in the loess media could be expressed by the filtration theory.
Maekawa, Fujio; Niita, Koji*; Meigo, Shinichiro; Kasugai, Yoshimi; Ikeda, Yujiro; Takada, Hiroshi; Ino, Takashi*; Sato, Setsuo*; ASTE Collaboration Team
JAERI-Conf 2001-002, p.983 - 991, 2001/03
no abstracts in English
